Rainbow Electronics MG260 User Manual
Page 244
FLYFOT-MG260-MODULE
Page: 244 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Defined values
20.3 FLYFOT Get Current GPS Locition +WGPSPOS
Description
This command used to get the current longitude, latitude and altitude.
Before use this commond , at+wgpsconf=1 must be executed
Syntax
Command syntax : AT+ WGPSPOS
Command
Possible responses
AT+ WGPSPOS ?
Long=,Lat=,Alt=
OK
Note : Command valid
20.4 FLYFOT Send Cmd TO Uart1 +WGPSRAW
Description
This command used to send setting cmd to ublox.
Syntax
Command syntax : AT+ WGPSRAW
Command
Possible responses
AT+ WGPSRAW=”AD012548”
OK
Note : Command valid
20.5 FLYFOT Open Auto Show +STARTGPSDATA
Description
This command used to open auto GPS data display
Syntax
Command syntax : AT+ STARTGPSDATA
Command
Possible responses
AT+ STARTGPSDATA
+GPS data is sending