Rainbow Electronics MG260 User Manual
Page 209
FLYFOT-MG260-MODULE
Page: 209 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
62
"SIM5VONLY"
5V SIM voltage mode
63
"SIM3AND5V"
Both 3 and 5V SIM voltage mode (def. 1)
7
"SIMREMOVE"
SIM removal feature (def. 1)
81
"NOINTERRUPT"
No management of interruption (def. 0)
82
"QUICKOFF"
Quick Off mode (def. 0)
83
"OFFWHENUNPLUG"
Off when unplug mode (def. 0)
84
"INTERRUPT"
interruption for customer (def. 1)
9
"SWITCHATT"
Switch Attenuation feature (def. 1)
A
"CPHS"
CPHS feature (def. 1)
B
"SIMSPEEDENH"
SIM speed enhancement feature (def.0)
C
"LOCA"
Location feature (def. 0)
Notes :
z
The +WFM response only use alphabetical values for the <FtrID> parameter.
z
For<FtrID>values with two digits (like 1x, 6x or 8x), the<mode>0 value is not allowed. When a «
xa » feature is enabled, enabling an other « xb » feature will automatically disable the « xa »
feature. For example, if the "MONO900" feature is enabled, if the "BI9001800" feature is
activated, the "MONO900"feature gets automatically disabled. Likewise, the "HR" feature and the
"ECHO" feature are exclusive. If “NOHR_NOECHO” is activated, both features “HR” and
“ECHO” are disabled.
z
“MONO900”, “MONO850”, “MONO1800”, “MONO1900”, “BI9001900”, “BI9001800”,
“BI8501900” and “QUADBAND” features are read-only. In order to change the Band selection
use AT+WMBS command, see §15.54.
<status>
0 : the <FtrID> feature is disabled
1 : the <FtrID> feature is enabled
<resetFlag>
0 : the feature has not been modified since the last boot of the product.
1 : the feature has been modified since the last boot of the product; a reset must be performed to take the
modifications into account.
Note: If a feature is reset to its initial value after a modification, the <resetFlag> parameter will be reset to
0.
18.36 Commercial Features Management +WCFM
Description
This command enables ou disables FLYFOT specific features. Disabling a feature can be done with no
restriction, but a password is required to enable features.