Rainbow Electronics MG260 - Manual (Page 21)

FLYFOT-MG260-MODULE
Page: 21 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
AT+CMEE=1
Note : Enable “+CME ERROR:<xxx>” or
“+CMS ERROR:<xxx>” OK
AT+CMEE?
+CMEE : 1
Note : Enable “+CME ERROR: <xxx>”
AT+CMEE=?
AT+CMEE +CME ERROR 3
Note: not support
Defined values :
<error reporting flag>
0 : Disable ME error reports, use only “ERROR”
1 : Enable “+CME ERROR: <xxx>”
4.15 Keypad control +CKPD
Description :
This command emulates the ME keypad by sending each keystroke as a character in a <keys> string.
The supported GSM sequences are listed in the appendix. If emulation fails, a +CME ERROR: <err>
is returned. If emulation succeeds, the result depends on the GSM sequence activated:
Note: In the case where the FDN phonebook is activated, the sequences concerning “call forwarding”
are allowed only if the entire sequence is written in the FDN.
Syntax :
Command syntax : AT+CKPD=<keys>
Command
Possible responses
AT+CKPD=”*#21#”
Note : Check every call forwarding status +CCFC: 0,7
AT+CKPD=”1234”
Note : Sequence not allowed +CME ERROR 3
Defined values :
<keys>
Keyboard sequence : string of the following characters (0-9,*,#).
4.16 Clock Management +CCLK
Description :
This command is used to set or get the current date and time of the ME real-time clock.
Syntax :
Command syntax : AT+CCLK=<date and time string>
Command
Possible responses