Rainbow Electronics MG260 - Manual (Page 29)

FLYFOT-MG260-MODULE
Page: 29 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
Note: The ”;” for speech calls
Defined values :
<nb>
destination phone number
<index>
call number at indicated offset from the phonebook selected by the +CPBS command
<name>
call number corresponding to given name from the phonebook selected by the +CPBS command
5.2 Hang-Up command H
Description:
The ATH command is used by the application to disconnect the remote user. In the case of multiple
calls, all calls are released (active, on-hold and waiting calls).
The specific FLYFOT ATH1 command has been appended to disconnect the current outgoing call,
only in dialing or alerting state (i.e. ATH1 can be used only after the ATD command, and before its
terminal response (OK, NO CARRIER...). It can be useful in the case of multiple calls.
Syntax :
Command syntax : ATH<n>
Command
Possible responses
ATH
Note: Ask for disconnection OK
Note: Every call, if any, are released
ATH1
Note: Ask for outgoing call disconnection OK
Note: Outgoing call, if any, is released
Defined values:
<n>
0: Ask for disconnection (default value)
1: Ask for outgoing call disconnection
5.3 Answer a call A
Description :
When the product receives a call, it sets the Ring Indication signal and sends the ASCII “RING”
string to the application. Then it waits for the application to accept the call with the ATA command.
Syntax :
Command syntax : ATA
Command
Possible responses
RING
Note: Incoming call