Rainbow Electronics MG260 - Manual (Page 25)

FLYFOT-MG260-MODULE
Page: 25 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
Syntax :
Command syntax : AT+TMEL=<type>,< volume>
Command
Possible responses
AT+TMEL=2,3
Note: Set the alert type and volume OK
AT+TMEL =?
Note: Get possible value +TMEL: (0-15),(1-3)
OK
AT+TMEL =10,4
Note: Set invalid value +CME ERROR: 3
Note: The product can not support this command
AT+ TMEL?
AT+ TMEL +CME ERROR: 3
Note: The product can not support this command
Defined values :
<type> The value range is 0-15
0: none alert tone
(1-15): different alert tone
<volume> The value range is 1-3
1: The volume is lowest
2: The volume is middle
3: The volume is topmost
4.22 Control Flash LED Command +TFLED
Description
This command with six parameters is used to control the flash led sparking.
Syntax
AT+TFLED=[Operation],<light time in idle>,<dark time in idle>,<light in calling>,<dark in
calling>,<mode:>
Command
Possible responses
AT+ TFLED =?
Note: Set the alert type and volume +TFLED:
(0-1),(0-65535),(0-65535),(0-65535),(0-65535),(0-1)
OK
AT+ TFLED =1,10,10,10,10 ,1
Note: Get possible value OK
AT+ TFLED =10,4
Note: Set invalid value +CME ERROR: 3
Note: The product can not support this command
AT+ TFLED?
+TFLED: 1,10,10,10,10,1
AT+ TFLED
+CME ERROR: 3
Note: The product can not support this command