Rainbow Electronics MG260 - Manual (Page 34)

FLYFOT-MG260-MODULE
Page: 34 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
5.10 Microphone Mute Control +CMUT
Description :
This command is used to mute the microphone input on the product (for the active microphone set
with the +SPEAKER command). This command is only allowed during a call. Syntax:
Command syntax : AT+CMUT=<mode>
Command
Possible responses
AT+CMUT=?
Note: Test command +CMUT: (0,1)
OK
Note: Enable / disable mute
AT+CMUT?
Note: Ask for current value +CMUT: 0
OK
Note: Current value is OFF
AT+CMUT=1
Note: Mute ON (call active) OK
Note: Command valid
AT+CMUT?
Note: Ask for current value +CMUT: 1
OK
Note: Mute is active (call active)
AT+CMUT=0
Note: Mute OFF (call not active) +CME ERROR:3
Note: Command not valid
Defined values :
<mode>
0 : microphone mute off (default value).
1 : microphone mute on.
5.11 Speaker & Microphone selection +SPEAKER
Description:
This specific command is used to select the speaker and the microphone set.