Rainbow Electronics MG260 - Manual (Page 51)

FLYFOT-MG260-MODULE
Page: 51 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
RxLev
4: Timing Advance
Combination (addition of the values) of the requested dump is supported. Note that in idle mode, only RxLev
measurements (on the main cell and on the neighbouring cells) are made. The value of these RxLev is set in the
RxLev Full field for the main cell.
The response will be:
+CCED :<value>, . , <value>
OK
Where <value> is the ASCII string of the values (in decimal form except the LAC and CI values which are in
hexadecimal form) of the parameters. If a field cannot be measured . or has no sense . the parameter is not filled
in (two consecutive commas are then found).
If the <requested dump> parameter is absent, that of the last +CCED command (or 15 by default) will be used.
Values of MCC/MNC are set to 0 in the case of .No service..