Rainbow Electronics MG260 - Manual (Page 15)

FLYFOT-MG260-MODULE
Page: 15 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
Command Possible responses
AT+CBC?
+CBC: n,m
OK
AT+CBC=?
+CBC: (0-3), (0-100)
OK
AT+CBC
+CBC: n,m
OK
AT+CBC=1
+CME ERROR 3
Note: not support
While the battery level changed the indicator will be send to TE.
Defined values :
<n>
0: battery not in charge
1: battery in charge
2: battery full
3: battery low
<m>
0: battery level 0
25: battery level 1
50: battery level 2
75: battery level 3
100: battery level 4
4.3 Manufacturer identification +CGMI
Description :
This command gives the manufacturer identification.
Syntax :
Command syntax : AT+CGMI
Command
Possible responses
AT+CGMI
Note: Get manufacture identification FLYFOT MODEM
OK
Note: Command valid, FLYFOT modem
AT+CGMI=? OK
AT+CGMI?
AT+CGMI=1 +CME ERROR 3
Note: not support
4.4 Request model identification +CGMM
Description :
This command is used to get the supported frequency bands. With multi-band products the response
may be a combination of different bands.