Rainbow Electronics MG260 - Manual (Page 172)

FLYFOT-MG260-MODULE
Page: 172 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
The supported events are: <event>
0 : The SIM presence pin has been detected as “SIM removed”
1 : The SIM presence pin has been detected as “SIM inserted”
2 : Calling party is alerting
3 : Product is ready to process AT commands (except phonebooks, AOC,
SMS), at init or after AT+CFUN=1
4 : Product is ready to process all AT commands, end of phonebook init or
swap (FDN to ADN)
5 : Call <idx> has been created (after ATD or +CCWA…)
6 : Call <idx> has been released, after a NO CARRIER, a +CSSU: 5 indication,
or after the release of a call waiting
7 : The network service is available for an emergency call.
8 : The network is lost.
9 : Audio ON.
10 : Show reload status of each SIM phonebook after init phase (after Power-ON or SIM insertion).
11 : Show the checksum of SIM phonebooks after loading
12 : An interruption has occurred
Or for event 10:
<phonebook> : SIM phonebook
“SM”
“FD”
“ON”
“SN”
“EN”
<status> :
0 : Not Reloaded from SIM (no change since last init or SIM removal)
1 : Reloaded from SIM to internal memory (at least one entry has changed)
Or for event 11:
<checksum> : 128-bit “fingerprint” of the phonebook.
Note : If the service of the phonebook is not loaded or not present, the checksum is not displayed
and two comas without checksum are displayed (,,).