Rainbow Electronics MG260 - Manual (Page 154)

FLYFOT-MG260-MODULE
Page: 154 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
15.15 Display configuration &V
Description
This command is used to display the modem configuration.
Syntax :
Command syntax : AT&V<n>
The parameters displayed are the following :
Q:val1, V:val2, S0:val3, S2:val4, S3:val5, S4:val6, S5:val7,
+CR:val8, +CRC:val9, +CMEE:val10, +CBST:val11,
+SPEAKER:val12, +ECHO:val13, &C:val14, &D:val15, %C:val16
+IPR:val17, +ICF:val18, +IFC:val19
Defined values :
<n>
0 : Display the modem configuration in RAM. (default value if no parameter provided)
1 : Display the modem configuration in EEPROM.
2 : Display the modem factory configuration.