Rainbow Electronics MG260 - Manual (Page 20)

FLYFOT-MG260-MODULE
Page: 20 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
<cfun state>
0: radio off
1: radio on
2: the system is initializing
3: radio off and the product at airplane mode
4.13 Phone activity status +CPAS
Description :
This command returns the activity status of the mobile equipment.
Syntax :
Command syntax : AT+CPAS
Command
Possible responses
AT+CPAS
Note : Current activity status +CPAS: <pas>
OK
AT+ CPAS?
AT+ CPAS=?
AT+ CPAS=1
+CME ERROR 3
Note: not support
Defined values :
<pas>
0: ready (allow commands from TA/TE)
1: unavailable (does not allow commands)
2: unknown
3: ringing (ringer is active)
4: call in progress
5: asleep (low functionality)
4.14 Report Mobile Equipment errors +CMEE
Description :
This command disables or enables the use of the “+CME ERROR : <xxx>” or “+CMS
ERROR :<xxx>” result code instead of simply “ERROR”. See appendix 16.1 for +CME ERROR
result codes description and appendix 16.2 for +CMS ERROR result codes.
Syntax :
Command syntax : AT+CMEE=<error reporting flag>
Command
Possible responses
AT+CMEE=0
Note : Disable ME error reports, use only
“ERROR”
OK