Rainbow Electronics MG260 - Manual (Page 54)

FLYFOT-MG260-MODULE
Page: 54 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
<puk> Personal Unblocking Key needed to change the PIN.
See above conditions of use.
7.2 PIN remaining attempt number +CPINC
Description :
This specific command is used to get the number of valid attempts for PIN1 (CHV1), PIN2 (CHV2),
PUK1 (UNBLOCK CHV1) and PUK2 (UNBLOCK CHV2) identifiers.
Syntax :
Command syntax : AT+CPINC
Response syntax : +CPINC : <n1>,<n2>,<k1>,<k2>
Command
Possible responses
AT+CPINC
Note : Get the number of attempts left
+CPINC : 2,3,10,10
OK
Note : First CHV1 attempt was a failure
AT+CPINC?
Note : Get current values
+CPINC : 2,3,10,10
OK
Note : First attempt was a failure
AT+CPINC=?
Note : Get possible values OK
Defined values
<n1>, <n2> are the attempts left for PIN1, PIN2 (0 = blocked, 3 max)
<k1>, <k2> are the attempts left for PUK1, PUK2 (0 = blocked, 10 max)
For this to work, the card should be present at the time of initialization, otherwise an error will be sent
(+CME ERROR : 10).
Note: if PIN2 not aviable , the n2 and k2 maybe 255
7.3 Facility lock +CLCK
Description:
This command is used by the application to lock, unlock or interrogate an ME or network facility <fac>.
Note: Test SIM cards (with MCC=001 & MNC=01) doesn’t check “PS”, “PN”, “PU”, “PP” and “PC”
locks.
Syntax :
Command syntax: AT+CLCK= <fac>,<mode>[,<passwd>[,<class>] ]
Response syntax: +CLCK: <status> [ ,<class1> ]<CR><LF>+CLCK: <status>,<class2> [ … ] ]
Command
Possible responses