Rainbow Electronics MG260 User Manual
Page 179
FLYFOT-MG260-MODULE
Page: 179 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
36
Icelandic
18.7 Write Language Preference +WLPW
Description :
Write a Language Preference value in EF-LP
Syntax :
Command syntax: AT+WLPW=<index >,<value>
Response syntax: OK or +CME ERROR: <err>
Defined values :
<index>:
offset in the available languages range (SIM dependant).
<value>
See <value> examples above.
18.8 Read GPIO value +WIOR
Description
Read the requested GPI or GPIO pin value.
z
Note : by default (e.g. after a reset), the I/O ports configuration is set by the +WIOM command.
z
This command is allowed only on a Gpio not allocated by an Open-AT embedded application or
for bus operations.
Syntax
Command syntax: AT+WIOR=<index>
Response syntax: +WIOR: <value>
Defined values
<index>
Eight I/O ports are available. The <index> value is between 0 and 7.