Rainbow Electronics MG260 - Manual (Page 230)

FLYFOT-MG260-MODULE
Page: 230 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
1 : mono-band mode 900 MHz
2 : mono-band mode 1800 MHz
3 : mono-band mode 1900 MHz
4 : dual-band mode 850/1900 MHz
5 : dual-band mode 900/1800 MHz
6 : dual-band mode 900/1900 MHz
<ResetFlag>
0 : the feature was not modified since the last boot of the product.
1 : the feature has been modified since the last boot of the product : it has to be reset in order to take the
modification into account.
18.52 Ring Melody Playback +CRMP
Description
This command allows a melody to be played. All melodies are manufacturer
defined.
For incoming voice, data or fax calls, 10 manufacturer-defined melodies can be
played back (in a loop).
Note:
loop melodies (for voice/data/fax call) must be stopped by a +CRMP command
with the <index> field set to 0 (example: +CRMP=0,,,0).
When the <volume> parameter is given, this overwrites the <sound level>
value of the +CRSL command. If the <volume> parameter is not given, the
<sound level> value of +CRSL is used as default value.
Syntax :
Command syntax : AT+CRMP=<call type>[,<volume>,<type>,<index>]
Command
Possible responses
AT+CRMP=0,7,0,2
Note : Play voice call melody index 2 with
volume level 7.
OK
Note : Melody Playback.
AT+CRMP=0,,,0
Note : Stop the melody. OK
Note : The melody is stopped.
AT+CRMP=?
Note : supported parameters +CRMP: (0-2),(0-15),0,(0-10)
OK