Rainbow Electronics MG260 - Manual (Page 189)

FLYFOT-MG260-MODULE
Page: 189 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
18.19 FLYFOT Select Voice Gain +WSVG
Description :
The product has 2 voice gain controllers, this specific command selects the microphone gain
controller.
Syntax :
Command syntax : AT+WSVG = <n>
Command Possible responses
AT+WSVG=<n>
AT+WSVG=0 OK
Note : Select Controller 1 (Default) Note : Controller 1 selected
AT+WSVG=1 OK
Note : Select Controller 2 (Default) Note : Controller 2 selected
AT+WSVG=? +WSVG: (0-1)
Note : Get the list of possible values Note : possible values 0 or 1
AT+WSVG? +WSVG: 1
Note : Get the current value Note : Controller 1 is selected
Defined values
<n> Controller
0 : Controller 1 (Default)
1 : Controller 2
18.20 FLYFOT Status Request +WSTR
Description :
This specific command returns some operation status. It can be used for example to check the state of
the initialisation sequence; the different values returned are Not started, Ongoing, Finished.
Syntax :
Command syntax: AT+WSTR=<status>
Response syntax: +WSTR: <status>,<value>
Command Possible responses
AT+WSTR=<status> +WSTR :<status>,<value>
AT+WSTR=1 +WSTR: 1,2
Note : Select the status 1 (INIT SEQUENCE) OK
Note : Init finished
AT+WSTR=2 +WSTR: 2,1
Note : Select the status 2 (NETWORK OK
STATUS) Note : The network is available