Rainbow Electronics MG260 - Manual (Page 145)

FLYFOT-MG260-MODULE
Page: 145 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
1 : 8 Data 2 Stop (not supported)
<parity>parameter is ignored.
2 : 8 Data 1 Parity 1 Stop (not supported)
if no<parity> provided, 3 is used by default as <parity>value.
3 : 8 Data 1 Stop (supported)
<parity>parameter is ignored.
4 : 7 Data 2 Stop (not supported)
<parity>parameter is ignored.
5 : 7 Data 1 Parity 1 Stop (not supported)
if no<parity> provided, 3 is used by default as <parity>value.
6 : 7 Data 1 Stop (not supported)
<parity>parameter is ignored.
<parity>
0 : Odd (not supported)
1 : Even (not supported)
2 : Mark (not supported)
3 : Space (not supported)
4 : None (supported)
Notes :
z Setting a character framing different from 8N1 will disable autobauding if it was activated. Setting
it back to 8N1 will not re-enable autobaud.
z Setting the framing to 8N1 will let the autobauding enabled, if it was already enabled (implying
framing was already 8N1).
15.3 DTE-DCE local flow control +IFC
Description :
This command is used to control the operation of local flow control between the DTE and DCE.
Syntax :
Command syntax : AT+IFC=<DCE_by_DTE>,<DTE_by_DCE>
Command
Possible responses
AT+IFC?
Note :
+IFC: 2,2
OK
Note : Current values
AT+IFC=?
Note : +IFC: (0,2),(0,2)
OK