Rainbow Electronics MG260 - Manual (Page 131)

FLYFOT-MG260-MODULE
Page: 131 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
AT+CGQMIN=? +CGQMIN:“IP”,(1-3),(1-4),(1-5),(1-9),(1-31)
+CGQMIN:“PPP”,(1-3),(1-4),(1-5),(1-9),(1-31)
OK
AT+CGQMIN? +CGQMIN: 1,1,4,5,2,14
OK
Defined values
<cid>: a numeric parameter which specifies a particular PDP context .
<precedence>: a numeric parameter which specifies the precedence class.
<delay>: a numeric parameter which specifies the delay class.
<reliability>: a numeric parameter which specifies the reliability class.
<peak>: a numeric parameter which specifies the peak throughput class.
<mean>: a numeric parameter which specifies the mean throughput class. If a value
is omitted for a particular class then this class is not checked.
13.7 Enter data state +CGDATA
Description
This command causes the MT to perform the necessary actions to set up communication between the TE
and the network. This may include performing a GPRS attach and one PDP context activation.
If the <cid> value is not defined to the MT, it will return an ERROR or +CME ERROR response.
Otherwise, the MT issues the intermediate result code CONNECT and enters V.25ter online data state.
GPRS attachment and PDP context activation procedures may take place prior to or during the PDP startup
if they have not already been performed using the +CGATT and +CGACT commands.
If no <cid> is given, the MT attempts to activate the context with available information. The other context
parameters are set to their default values (No APN, default QOS parameters, dynamic IP address
requested).
If the activation is successful, data transfer may proceed.
After data transfer and layer 2 protocol termination procedure completion, the V.25ter command state is
re-entered and the MT returns the final result code OK.
In case of abnormal termination or start up, the V.25ter command state is reentered and the MT returns the
final result code NO CARRIER or, if enabled, +CME ERROR. Attach, activate and other errors may be
reported.