Rainbow Electronics MG260 - Manual (Page 100)

FLYFOT-MG260-MODULE
Page: 100 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
2: Place all active calls (if any exist) on hold and accepts the other (held or waiting) call.
2X: Place all active calls on hold except call X with which communication is supported.
3: Adds a held call to the conversation.
4: Connects the two calls and disconnects the subscriber from both calls (Explicit Call Transfer).
10.9 List current calls +CLCC
Description:
This command is used to return a list of current calls.
Syntax:
Command syntax: AT+CLCC
Response syntax: OK (if no calls are available)
+CLCC : <id1>, <dir>, <stat>, <mode>, <mpty> [,<number>, <type>
[<alpha>]] [<CR><LF>
+CLCC: <id2>, <dir>, <stat>, <mode>, <mpty> [ ,<number>, <type>
[<alpha>]][...]]] <CR><LF>
Command
Possible responses
When a call incoming
run: AT+CLCC? “+CLCC: 1,1,4,0,0,"01062965555",129”
ATD1860;
AT+CHLD=2
ATD 1861;
AT+CLCC?
OK
OK
OK
+CLCC: 1,0,1,0,0,"1860",129
+CLCC: 2,0,0,0,0,"1861",129
Note: list current calls. One is active, one is
held. They both are MO call.
Defined values :
<idx> integer type, call identification as described in GSM 02.30
<dir> (direction of the call)
0: mobile originated (MO) call
1: mobile terminated (MT) call
<stat> (state of the call):
0: active
1: held
2: dialling (MO call)
3: alerting (MO call)