Rainbow Electronics MG260 - Manual (Page 91)

FLYFOT-MG260-MODULE
Page: 91 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
9.21 Cell Broadcast Message Identifiers +WCBM
Defined values :
This specific command is used to read the EF-CBMI SIM file.
Remark: The EF-CBMI file is not used with the +CSCB command. The application should read this file
(using AT+WCBM ?) and combine the Message Identifiers with those required by the application.
Syntax
Command syntax : AT+WCBM= <mids>
Command
Possible responses
AT+WCBM=.10,100,1000,10000.
Note : Write 4 messages identifiers in EFCBMI OK
Note : CBMIs are stored in EF-CBMI
AT+WCBM?
Note : Read the CBMIs in EF-CBMI +WCBM=.10,100,1000,100000.
OK
Note : 4 CBMIs are stored in EF-CBMI
AT+WCBM=? OK
Defined values :
<mids>:See above descriptions
9.22 Capacity of SIM card been adjusted +TSMC
At present MG260 do not support this command.
Indicator
Receiving message
“+TSMC:<num>”
Note: inform PDA that the capacity of SIM card been
adjusted. APPI_SMS_STATUS_MSG_LIST_IND
Defined values :
<num>: the new capacity of SIM card.