MTS Series 793 - Manual (Page 103)

Defining calculation equations
Once you have defined the calculation resources needed to run your test, you must use the Station Manager
application to specify the equation used for each calculation.
How to Create a Calculated Analog Output Resource
1. In the Station Builder navigation pane, select Calculated Outputs.
2. In the Hardware Resources list, select the resource you want to allocate, and then click +.
3. In the Internal name box, select or type the desired name.
4. Optional—in the Display name box, type the desired name.
5. Set the Dimension and Display Units for the calculated output signal.
6. Use the Station Manager application to define the calculation.
How to Create a Calculated Digital Output Resource
1. In the Station Builder navigation pane, select Digital Outputs.
2. In the Hardware Resources list, select the <<Virtual Output>>, and then click +.
3. In the Internal name box, select or type the desired name.
4. Optional—in the Display name box, type the desired name.
5. In the Source box, select Calculation.
6. Use the Station Manager application to define the calculation.
How to Create a Calculated Input Resource for Control Modes
1. In the Station Builder navigation pane, select Channels.
2. On the Control Modes tab, select the <<Calculated Input>> resource from the Input Resources list, and
then click +.
3. In the Internal name box, select or type the desired name.
4. Optional—in the Display name box, type the desired name.
5. Set the Dimension and Display Units for the calculated input signal.
6. Use the Station Manager application to define the calculation.
MTS Series 793 Control Software 103
Station Builder