MTS Series 793 - Manual (Page 141)

Description Item
Channels appear with the control mode dimension used by the external
program signal.
Moves the selected Available Channels/Modes item to External
Command Channels.
Lists the channels controlled as a group through an external program
source. External Command Channels
By default, new configurations place all control channels with external
inputs into External Command Channels.
Moves External Command Channels item to Available Channels/Modes.
Master Command Tab
This tab defines channels that are programmed as a group through internal test station signals.This tab’s
controls are unavailable for single-channel systems.
The Function Generator panel, Setpoint and Span window, and Manual Command window provide the program
signals for master command groups.
Note:
Requires Tuning access level (or higher) to edit any item.
Access
Tools menu > Channel Options > Channel Options window > Master Command tab
Description Item
Enter a name for the master command group selected below. Group Name
Lists master command groups. Master Command Groups
Adds a new Group Name to the Master Command Groups. Add Group
Deletes the selected master command group from the Master Command
Groups. Delete Group
Selects the dimension to be used by the master command group. Only
channels with the selected dimension will display in Available
Channels/Modes. Channel Dimension
Lists the available channels with the control modes that can be selected
as Master Command Channels. Available Channels/Modes
If more than one control mode/range match exists, both are displayed,
but only one can be added to the Master Command Channels.
MTS Series 793 Control Software 141
Station Manager Application