MTS Series 793 - Manual (Page 256)

Item Callout
Function Generator (or Drive File) 1
Desired 2
Compensation Filter 3
Drive 4
Test System 5
PID Controller 6
Actuator 7
LVDT 8
Position Feedback 9
Inverse System Identifier 10
Response 11
AIC Tab Settings
Description Item
Sets how quickly compensation values are applied to converge the feedback
and command signals. Convergence Rate
Sets a time delay between the desired and response signals. Anticipation
Sets the length of the adaptive filter, which influences how completely the
dynamics of the controller/actuator/specimen combination are cancelled. Impulse Response
Sets the crossover frequency. Crossover Freq
When applying AIC to a dual compensation mode configured in the Station
Builder application for Amplitude Control Only, set this control to 0.
Allows the selection of a required type of pre-emphasis filter. Pre-emphasis Filter
256 MTS Series 793 Control Software
Station Setup