MTS Series 793 - Manual (Page 32)

Important:
By default, the Calibration Files subfolder exists outside of the Project folder, so when you archive a
Project, the files within the Calibration Files subfolder will not be archived.
Folders that cannot be located by the Project Manager
A folder with this type of annotation means the Project Manager cannot find the subfolder specified in the
Project Settings file. In short, it means the link between the Project Settings file and the folder is broken. This
annotation is a useful diagnostic feature that aids in troubleshooting broken links.
Broken links occur when you inadvertently rename or delete Project subfolders using Windows Explorer. This
can also occur if you rename a Project subfolder (or setting) using the Project Manager while editing the
Project Settings file.
In either case, you must make the folder name in the path specified in the Project Settings file match the
actual folder name, or create the folder, to fix the problem.
More about Project Information
By default, a Project’s Calibration Files, Config, and Procedure Templates folders are referenced from locations
outside of the Project folder, as shown below.
Sample Project as displayed in Project Manager
The Sample Project above shows the folders that are referenced by default. The locations of the referenced
folders are shown to the right.
32 MTS Series 793 Control Software
Project Manager