MTS Series 793 - Manual (Page 134)

Station View Options Tab
Access
Tools menu > Station Options > Station Options window > Station View Options tab.
Description Item
This default selection displays Station Limits status indicators on
the Station Manager Station Controls panel. Display Station Limits on Main
Window
This default selection displays the Master Span controls on the
Station Manager Station Controls panel. Display Master Span on Main
Window
Note:
If the Master Span is not displayed in the Station Manager
main window, it is displayed in the Setpoint and Span
windows.
Select to always display the Station Manager main window at the
“on top” display level. Main Window Always On Top
Select to display the Rig Command buttons on the Station
Manager’s Station Controls panel. The Rig Commands are also
displayed on the Station Manager Manual Command window. Display Rig Command on Main
Window
Note:
Rig Commands is an optional feature.
Select to remove individual HSM controls (with the exception of
the All HSM control) from the Station Controls panel and replace Hide HSMs
them with a Show HSMs button. When this button is pressed, an
HSM window, with individual controls for each HSM, appears.
Station Integrator Control
(Parameter Set) Note:
You must be at the Tuning access level to change this
control.
Use the Integrator Mode control to set how integration is applied
to all channels in the station:
• Manual—Displays an Integrators box on the Station Controls
panel that contains a Manual State control. The Manual State
control allows you to select one of the following:
Enabled—turns the integrator on, provided system hydraulics
are set to Low.
Disabled—turns the integrator off, which causes the integrator
to hold or delay for one second, and then to decay to zero in
the following second.
134 MTS Series 793 Control Software
Station Manager Application