MTS Series 793 - Manual (Page 404)

b) For Plot Mode, select Time.
3. Customize the plot as required:
• In the toolbar, click the Setup Scope icon to set up the scope display as desired using the Graph and
Trace tab controls.
• Units/div–specifies the grid line values.
• Offset–specifies how much the grid’s zero reference on the Y axis shifts from the center of the display.
• Trace Time–Specifies the length of time for a signal trace to cross the scope (also sets the grid’s X
axis scale). You can jog the values up and down with the up-down control.
When the scope is running and displays time plots, the time Pan-Zoom control is disabled, but the Y1
and Y2 axis’ Pan-Zoom controls are enabled.
How to Set Up a Frequency Plot
1. In the Station Manager window’s toolbar, click the scope icon to display the scope window.
2. In the Scope window:
a) For Channel, select the channels whose signals you wish to monitor.
b) For Signal, select the signals you wish to monitor.
404 MTS Series 793 Control Software
Scopes and Meters