MTS Series 793 - Manual (Page 232)

Master Span groups
A Master Span channel group has a common span. Use the Channel Options window’s Master Span tab to
define Master Span groups.
The span for a Master Span group is adjusted through the Station Manager window’s Station Controls panel’s
Master Span.
How to Create a Master Command Group
1. Select a Station Manager access level of Tuning or Calibration.
2. If required, clear the Exclusive Control check box.
3. On the Tools menu, click Channel Options.
4. In the Channel Options window, click the Master Command tab.
5. On the Master Command tab, define a Master Command group:
a) Click Add Group and enter the new Group Name.
b) Select the Channel Dimension to be used by the group. This selection determines the Available
Channels/Modes.
c) Select an Available Channel Mode and click the > button to add it to the Master Command Group.
To remove a Channel Mode from the Master Command Group, select the Channel Mode and click the
< button.
How to Create a Master Span Group
1. Select a Station Manager access level of Tuning or Calibration.
2. On the Tools menu, click Channel Options.
3. In the Channel Options window, click the Master Span tab.
4. On the Master Span tab, define a Master Span group:
a) Click in Available Channels to select channels.
b) Use the < > buttons to move highlighted selections between Available Channels and Master Span
Channels.
By default, all channels start off as Master Span Channels.
The Station Controls panel’s Master Span becomes unavailable if no Master Span Channels are
selected.
232 MTS Series 793 Control Software
Station Setup