MTS Series 793 - Manual (Page 273)

3. If necessary, adjust the Gain and Offset to scale the output signal.
Note:
With Gain = 1 and Offset = 0 V (default values): a positive full-scale signal = +10 volts and a negative
full-scale signal = -10 volts.
Auxiliary Inputs
About Auxiliary Inputs
Auxiliary inputs are input signals that are typically used for data acquisition. Auxiliary inputs are configured
in the Station Setup window using the same setup tabs as control mode inputs.
Before auxiliary inputs appear in the Station Manager application, you must use the Station Builder application
to assign input resources to each auxiliary input that you create.
MTS Series 793 Control Software 273
Station Setup