MTS Series 793 - Manual (Page 303)

Item Callout
HSM - Controls hydraulic service manifolds through Power Off,
Power Low, and Power High buttons.
The names of station power resources originate in the hardware
interface file (.hwi) associated with the station configuration.
You can edit the name of these resources with the Hwi File
Editor application.
Sets the master span for all channels included in a master span
group. 24/25 - Master Span
MPT procedures where the MPT Option Editor window’s Span
control is set to Disable and Reset makes this control
unavailable.
Use the Channel Options window’s Master Span tab to define
master span groups.
The Station Option window’s Display Master Span on Main
Window control must be selected to display this control. If this
selection is not made, Master Span will be displayed in the
Setpoint and Span window.
Sets the master gain for all station channels. Master gain is a
multiplier of the gains for all the PID control loops in your station. 24/25 - Master Gain (Option)
About the Station Controls Toolbar
The Station Controls toolbar provides access to additional controls that allow you to apply offsets, set detectors,
set digital inputs and outputs, and manually position the actuator to install and remove the specimen.
Station Controls Panel Toolbar
Description Item
Auto Offset
Use the Signal Auto Offset window to monitor station signals and apply
auto-offsets as required.
Detectors
Use the Detectors window to view Limit status and change Limit values.
CAN Bus Ports
Use the CAN Bus Ports window to access all CAN Bus controls.
Digital I/Os
Use the Digital I/Os window to test digital outputs and view digital input
and output status.
MTS Series 793 Control Software 303
Using Station Manager to Run Tests