MTS Series 793 - Manual (Page 154)

C-Stop Tab
This tab allows the user to configure C-Stop interlock parameters. Configuration access level is required to
edit settings on this tab.
Access
Tools menu > Channel Options > Channel Options window > C-Stop tab
Description Item
Select number of C-Stop interlocks. The equivalent number of C-Stop tabs will
be displayed, allowing discrete settings for each C-Stop. Number of C-Stops
Global C-Stop Enable check box. Enables defined C-Stop actions. C-Stop Enable
Enter a display name for the selected C-Stop. The name entered in this field will
be displayed on the Station Controls panel and in the system actions list. Name
Select this check box to display a button for the selected C-Stop on the Station
Controls panel. Enable on Station
Controls
Displays a list of available channels. Channel
Use the drop down list to define the behavior of the C-Stop for each selected
channel. Select Hold at Level or one of the Ramp To Level options. Behavior
Select the channel’s active control mode for the controlled stop. Control Mode
Allows Program Stop to complete before initiating C-Stop defined behavior. Wait for Program Stop
Select this check box if the channel output might be unstable when a C-Stop is
asserted. Zero Output
The target end level. Only available for Ramp To Level behaviors. Target
The amount of time to complete the ramp to the specified target end level (used
with Ramp To Level-Time). Ramp Time
The rate of the ramp (in units/second) to the target end level (used with Ramp
To Level-Rate.) Ramp Rate (Units/s)
154 MTS Series 793 Control Software
Station Manager Application