MTS Series 793 - Manual (Page 464)

• Project name
Shortcut command line
To create a Station Builder shortcut command line, first specify the application (stbd), then the desired station
options.
The syntax of the shortcut command line is critical. If you do not use a supported command-line format, the
shortcut will not work.
To view a list of available Station Builder command-line options, enter stbd /H. These options are also described
in the following table.
Note:
If the parameter name contains spaces (for example, test 257.000), the name must be enclosed in
quotation marks (“test 257.000“).
The Station Builder application supports two command-line formats: decorator-based and precedence based.
Station Builder Command-Line Options
Example Default value Abbreviation
4
Prefix Parameter
/St practice.cfg None /St /Station Configuration file
/Hw tsiis.hwi None /Hw /hwi .hwi file name
/Cont “Control A” None Cont /Controller Controller name (to
connect to)
/Launch Project1 None None /Project (Project
name) Launch Project
/H ? or /Help Display the Station
Builder command-line
options
Command line example
Stbd /St stat1.cfg
System Loader Shortcuts
For System Loader, you can use a shortcut to automatically launch a simulated DSP or supervisor, load/unload
a simulated system, and specify the controller name.
Shortcut command line
To create a System Loader shortcut command line, first specify the application (sysload), then the desired
station options.
4
Option names can be abbreviated to anything that is unique.
464 MTS Series 793 Control Software
Command Line Shortcuts