MTS Series 793 - Manual (Page 194)

Description Item
Displays the name of the sensor file selected in the Sensor File list. Sensor File Name
Displays the conditioner type specified in the Hwi File Editor application. Conditioner Type
Basic TEDS information for the sensors that have a TEDS chip. (Series 494
Hardware only.) Basic TEDS
User defined. Conditioner Serial Number
Displays the dimension defined in the Station Builder application. Dimension
User defined. Last Calibration Date
User defined. Hardware Resource
Each mezzanine card connector on a Model 494.40 I/O Carrier Board includes
an LED that you can switch on and off using the LED State check box. Select LED State (Series 494
Hardware only)
the check box to switch the LED on. Click to clear the check box to switch
the LED off.
Service Port Output (Model
494.16/.25/.26 only) Note:
Available for Model FlexTest 40, 60, 100, and 200 controllers.
Makes signals from Models 494.25 DUCs, 494.26 DUCs, and the Model
494.16 VD/DUC available from the Model 494.40 I/O Carrier card’s Service
connector.
Select a signal to monitor:
• A/D Input—Conditioned feedback signal from the DUC portion of the
Model 494.16 VD/DUC.
• + Ex Voltage—The excitation sense voltage delivered to the transducer.
• Preamp Output—(transducer output) x (preamp gain)
• Sumamp Output—A slightly attenuated, inverted version of the preamp
output signal. In some custom applications, the preamp output signal may
be summed with an external signal.
Note:
These selections are not saved with the parameter set.
Accel Tab
This tab appears when a Model 494.21 Elastomer DUC is used in the control channel. This card provides
acceleration compensation with on-board summing of the load cell signal and an accelerometer signal. The
accelerometer measures the load applied to the load cell due to acceleration of the load cell at high frequency.
Access
Station Setup window > navigation pane > Channels control > Accel tab.
194 MTS Series 793 Control Software
Station Setup