MTS Series 793 - Manual (Page 205)

Description Item
These buttons apply and remove the shunt. On/Off
Saves settings from the Sensor, Calibration, and Shunt tabs to the current
sensor file. Save
Displays the Save Sensor File As window if no file has been created.
Restores the values on the Sensor, Calibration, and Shunt tabs from the
sensor file or Transducer ID. Restore
Restore is disabled if the input signal does not have a sensor file assigned
or the input signal control mode is the active feedback with the system
hydraulics on.
Offset/Zero Tab Settings
How to Access Offset Zero Settings
Method 1
Click a control mode and then click the Channel Input Signals button to display the settings for that control
mode input.
Method 2
Under the Inputs list, click the input that you want to configure and then click the Offset/Zero tab.
Method 3
On the Station Controls toolbar, click the Auto Offset button to display the Signal Auto Offset window.
MTS Series 793 Control Software 205
Station Setup