MTS Series 793 - Manual (Page 330)

How to Select a Master Command Group for the Function Generator
1.
In the Station Manager application Controls panel, click .
2. In the Function Generator panel, select a Master Command group.
a) Click Channel to change this button to Group.
The Group button will be unavailable if no Master Command group has been defined.
b) In the Group list, select a Master Command group.
c) The Control Mode switches to the mode(s) associated with the Master Command group when the
Station Controls panel is clicked or when the Manual Command window’s Enable Manual Command
is selected.
About Function Generator Wave Shapes
The Function Generator provides the following wave shapes.
330 MTS Series 793 Control Software
Using Station Manager to Run Tests