Rockwell Automation 5730 DriveLogix5730 Controller for PowerFlex 700S Drives with Phase II Control - Manual (Page 115)

Communicating with Devices on an EtherNet/IP Link 6-11
Controller Connections
Over EtherNet/IP A Logix system uses a connection to establish a communication link
between two devices. Connections can be:
• controller to distributed I/O or remote communication modules
• produced and consumed tags
• messages
You indirectly determine the number of connections the controller uses by
configuring the controller to communicate with other devices in the system.
ahw08
56.tif
4. Select where the EtherNet/IP devices reside. The software locates valid IP addresses.
Click OK.
ahw085
7.tif
5. The driver is now available and you can select the EtherNet/IP port in RSLogix 5000.