Rockwell Automation 5730 DriveLogix5730 Controller for PowerFlex 700S Drives with Phase II Control - Manual (Page 86)

4-16 Configuring DriveLogix Motion
Configuring the Drive with
DriveExecutive Software In DriveExecutive software, connect to the drive and access the Display
DriveLogix dialog as shown below:
Next link the appropriate parameters to the words being produced and
consumed by the controller.
1.From the Drive Menu, select Display DriveLogix.
ahw0824.tif
2.Click on the From DriveLogix tab.
ahw082
5.tif
3.Verify that the Communication Format
is set to Motion Control.
Click OK to apply and close the DriveLogix Setup
Dialog.