Rockwell Automation 5730 DriveLogix5730 Controller for PowerFlex 700S Drives with Phase II Control - Manual (Page 36)

2-12 Placing and Configuring the Drive
inhibit or 0 to uninhibit). Use a SSV instruction to write the Mode attribute
back to the module. For example:
Using DriveExecutive Lite In order to launch DriveExecutive Lite from within RSLogix 5000, the
drives power rating must be selected. The drive firmware revision must be
applied prior to selecting the power rating.
ah
w0514.tif
1. If not already done, enter the drive firmware revision. Click the Finish button to apply the
revision data.
ahw0779.ti
f