Rockwell Automation 5730 DriveLogix5730 Controller for PowerFlex 700S Drives with Phase II Control - Manual (Page 213)

Index-3
I
I/O
accessing data 3-12
accessing distributed on ControlNet 7-5
accessing distributed on EtherNet/IP
6-13
configuring local 3-7
ControlNet 7-4
DeviceNet 8-2
direct connections 3-14
distributed over EtherNet/I/P 6-12, 6-31
end-cap detections 3-15
generic 1769-MODULE 3-17
hold last state 3-8
inhibiting 3-9
layout 3-3
max modules A-1
max number banks A-1
module faults 3-15
monitoring 3-15
placing 3-2
update 3-4
user-defined safe state 3-8
inhibiting
I/O 3-9
the drive connection 2-11
installing
Compact I/O cable B-8
daughtercard B-9
DH-485 network 9-6
DriveLogix5730 Expansion Board B-7
Embedded EtherNet/IP Option B-7
new battery B-5
K
keying 2-4
L
loading
firmware 1-2
firmware with AutoFlash 1-4
firmware with CompactFlash 1-4
firmware with ControlFlash 1-3
local I/O C-1
M
mapping 7-12
addresses EtherNet/IP communication
to non-Logix controllers 6-22
Motion Control communication format
2-8
Position Control communication format
2-7
Speed Control communication format
2-6
User-Defined 1 communication format
2-9
User-Defined 2 communication format
2-10
master/slave communication methods 5-8
memory
specifications A-1
messages
ControlNet 7-9
EtherNet/IP 6-19
Motion Control
communication format 2-8
N
network settings
EtherNet/IP 6-2
P
placing
drive 2-3
I/O 3-2
Position Control
communication format 2-7
Powering Down 1-2, 2-1, 3-1, 4-1, 5-1, 6-1,
7-1, 8-1, 9-1, B-1
producing and consuming data
ControlNet 7-14, 7-20, 7-23
EtherNet/IP 6-15
programming ASCII instructions 5-12
programs
defining 1-8
developing 1-6
R
remote connection
serial link 5-7