Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 111)

3-32 Operator Interface
7000-UM150I-EN-P – June 2013 7000 “B” Frame
Drive Setup
This section describes how to:
• select an alternate language
• enter data to a drive parameter
• assign a tag to an analog port
• enable and disable a fault via a mask
• assign text to be associated with optional external fault inputs
• re-enter Setup Wizard
• configure the XIO link
• define the tags to be accessible by a PLC.
You will access the "SETUP" screen from the Top Level Menu by
pressing the [F8] key. This will result in the typical screen shown in
Figure 3.39 .
The Current Access level is shown. If it states 'Monitor' then you are
restricted to only viewing the basic drive setup. You cannot make
any changes. You must be in at least the 'Basic' access level in order
to modify any of the drive parameters, and you may only modify the
parameters for which you can view at the given access level.
At power-up, the operator interface access level is 'Monitor'. If this
is the current mode and you wish to change any of the setup data,
press the [F8] key now in order to change the access level before
proceeding into any of the other setup operations available from this
screen (Figure 3.40). Refer to the section Enter/Modify an Access
Level .
Figure 3.39 – Setup Screen