Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 37)

2-2 Drive Installation
7000-UM150I-EN-P – June 2013 7000 “B” Frame
Transportation and Handling
The PowerFlex 7000 drive is shipped on a wooden skid, which is
bolted to the underside of the cabinetry. The drive should remain
bolted to the shipping skid until it is delivered to its final installation
area. Lifting angles are supplied bolted to the top of the cabinetry.
The drive must be kept in an upright position during any handling.
Refer to “General Handling Procedures, publication 7000-IN002_-EN-P
for a more detailed description.
The drive must be transported on a pallet or via use of the lifting
beam supplied as part of all 2300-mm (91-inch) high cabinets.
A T T E N T I O N A T T E N T I O N Ensure that the load rating of the lifting
device is sufficient to safely raise the
controller sections. Refer to the packing slip
enclosed with shipment for shipping
weights.
Round rollers can be used to assist in moving the drive to the
installation site. Once at the final site, the pipe rolling technique can
be used to place the cabinet in the desired position.
W A R N I N G W A R N I N G Care must be exercised when using either a
forklift or the pipe rolling technique for
positioning purposes to ensure that the
equipment is not scratched, dented or
damaged in any manner. Always exercise
care to stabilize the drive during handling to
guard against tipping and injury to personnel.
NOTE: It cannot be sufficiently stressed how important it is that the
customer installation duties are performed correctly. Any errors will
certainly cause delays in the drive commissioning, if not damage as
well.
Never attempt to lift or move the drive by any means other than the
methods listed, as structural damage or personal injury could result.
The following methods of handling are recommended: