Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 89)

3-10 Operator Interface
7000-UM150I-EN-P – June 2013 7000 “B” Frame
b) Obtaining Drive Database - During this phase, the database of
information about the drive is obtained from the drive.
Obtaining the database at this point in time is optional and may
be aborted by pressing any key on the operator interface.
Obtaining the entire database does however speed up subsequent
operations since relevant portions of the database do not have to
be obtained. (Without obtaining the entire database, the operator
interface will access portions of the drive database as required.
This slows down the first access to the operation that requires the
data. Subsequent operations requiring the same data are not
affected). Aborting the download will not affect portions of the
database already obtained.
Once the database has been obtained, the operator interface will start
up in one of two modes, depending on to what degree the drive has
previously been configured:
a) On an unconfigured drive, the operator interface will enter the
'Setup Wizard' mode. Until the user has gone through the entire
'Setup Wizard', this will be the default mode to power up in. The
'Setup Wizard' can be cancelled at any time by pressing the
appropriate softkey.
b) Once the drive has been configured through the 'Setup Wizard',
the Top Level Menu, will be displayed from this point forward.
The 'Setup Wizard' can be re-entered via the Setup Menu.