Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 139)

3-60 Operator Interface
7000-UM150I-EN-P – June 2013 7000 “B” Frame
- 28F010
- 28F020
- 28F008SA
- 28F016SA.
These chips are used in the following memory cards available from
Rockwell Automation:
2711-NM11 2711-NM24
2711-NM12 2711-NM28
2711-NM14. 2711-NM216
This section describes how you will transfer information between these
two forms of flash memory and the drive. You will learn how to:
• Format a flash card.
• Look at the directory of files on a flash card containing the DOS
file format.
• Select a program (firmware) from the flashcard and load it into
the operator interface.
• Save the parameters from the drive on the flash card or in the
operator interface.
• Download parameters to the drive from a flash card or that
previously saved in the operator interface.
• Load a language module from the flash card.
You will access the Transfer operations from the Utility screen by
pressing the [F7] key. This results in the display of the screen shown
in Figure 3.87.
Figure 3.87 – Transfer Main Menu
From this screen, additional screens are used to perform the various
functions involving the flash memory. The screen shows the current
access level of the operator interface. Any operation that will alter
the contents of the flash memory or of the drive requires the access
level to be something other than 'Monitor'. At the 'Monitor' level you
may view the contents of the flash card. To change the access level,
press the [F8] key. Refer to the section Enter/Modify an Access
Level .