Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 405)

Component Definition and Maintenance 6-115
7000 “B” Frame 7000-UM150I-EN-P – June 2013
Printing (Uploading) Overview
Data from the Drive
The data from the drive; such as drive setup, parameters, variables,
trend data, fault masks, alarm queues etc., can be uploaded and saved
into laptop using HyperTerminal program. When using the
HyperTerminal program to upload the data, you will be prompted to
select a file to store this data. Therefore, you need to open an empty
Notepad file and then save that file on your pc before uploading the
data from the drive. The following example illustrates the method to
create an empty .txt file (example1.txt) and upload (or print) the data
from drive into laptop.
Required
-
Laptop with HyperTerminal program
-
A null-modem cable with a 9-pin female connector for the laptop
serial port, and a 9-pin male connector for the CIB
Communication Port (J8). (A serial cable with pins 2-3 swapped
at one end will also work)
Here is a typical pin out of a complete null-modem cable.