Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 388)

6-98 Component Definition and Maintenance
7000-UM150I-EN-P – June 2013 7000 “B” Frame
Hit F10 to Exit, and then F5 for NVRAM. Press F5 for SAVE, and
F8 for YES. The parameters should now be saved to NVRAM.
Press F10 again to EXIT.
To save to the Operator Interface Terminal and Flash Card, Press F2
(UTILITY), F7 (TRANSFER), and F4 (PARAMETERS). You
should now be on the following screen:
In order to save parameters to the Operator Interface Terminal, press
F5 (DRV>MEM). To save to the Flash Card, you must first insert
the card in the terminal. Remove the back cover and insert the card
in the slot on the terminal. It can only go in one way. Then press F4
(DRV>CRD).
Saving to the card means that you will have to choose a file name.
Use the Up and Down arrows to select the character, and then use the
Right arrow to go to the next character. Press the Enter key when
finished.
Press F8 for YES, and the parameters will be transferred to the card.
Press F10 to EXIT.
Download Mode
If the drive is running, you will not be able to place it into firmware
download mode. Ensure the drive is stopped, and the E-Stop is
pressed. This is just a precaution, as all versions of firmware 2.xxx
and later will not allow you to attempt a firmware download while
running.