Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 330)

6-40 Component Definition and Maintenance
7000-UM150I-EN-P – June 2013 7000 “B” Frame
The snubber and sharing resistors are part of the resistor assembly
located behind the PowerCage.
1. Remove the PowerCage as outlined in “PowerCage Removal”.
2. Note the connection of the leads for correct replacement.
3. Detach the leads located on the bottom of the resistor assembly.
Snubber Capacitor
Sharing Resistor Connection
Snubber Resistor Connection
Common Snubber and
Sharing Resistor Connection
Anode Connection
Cathode Connection
Push Nuts
Push Nuts
Snubber Capacitor
Sharing Resistor Connection
Snubber Resistor Connection
Common Snubber and
Sharing Resistor Connection
Anode Connection
Cathode Connection
Snubber Capacitor
Sharing Resistor Connection
Snubber Resistor Connection
Common Snubber and
Sharing Resistor Connection
Anode Connection
Cathode Connection
Push Nuts
Push Nuts
Figure 6.27 – Removal of Power Cage
(SGCT Type PowerCage shown)
4. Remove the push nuts on the end of the retaining rod. Pinch the
clip together and pull off. Pull out the retaining rod.
Snubber and Sharing
Resistor Replacement