Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 123)

3-44 Operator Interface
7000-UM150I-EN-P – June 2013 7000 “B” Frame
These are shown on separate screens. The type of PLC word being
viewed is defined to the right of the screen name, i.e. PLC SETUP:
INPUTS or PLC SETUP: OUTPUTS. To switch to the other screen,
press the [F8] key. Each press of the [F8] key will toggle the screen
to show the other set of words.
The layout of the PLC 'rack' is dependent on the DIP switch settings
on the RIO adapter, (refer to the appropriate manual for information
on the following adapters and their use: 1203-GD1, 1203-GK1,
1203-CN1, 1203-GD2, 1203-GK2, 1203-GK5, 1203-GU6, 1203-
SM1 and 1203-SSS). Tags are assigned to rack module locations in
pairs. These pairs are referred to as links and consist of two input
and two output words. There are a total of four links that can be
assigned to the RIO adapter.
The screens show the current tags and their tag code, which are
associated with each of the links. To change the tag attached to a
link, use the [cursor up] and [cursor down] keys to highlight the
desired link and press the [enter] key. (If nothing happens then you
have not gained the required access to make changes. Exit to the
SETUP screen and refer to the section entitled Enter/Modify an
Access Level to gain access).
Figure 3.60 – PLC Input Links
Figure 3.61 – PLC Output Links