Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual - Manual (Page 124)

4-38 GV3000/SE AC Drive Software Reference, Version 6.06
P.043 Fault Auto Reset Attempts (continued)
Table 4.5 lists the faults that can be auto reset:
All other faults cannot be auto reset.
Note that the auto reset feature will be disabled during the vector self-tuning operation
and the V/Hz identification procedure.
After the drive has detected the fault and is counting down the auto-reset time period,
the display will flash the countdown period in seconds in the following format:
"Ar30...Ar29...Ar28.........Ar01...Ar00"
If during this countdown, the operator presses the keypad STOP/RESET key, or
asserts the fault reset from the selected control source, the auto-reset countdown will
stop, and all faults will be reset.
Table 4.5 – Faults That Can Be Auto Reset
Fault Code Description
AIn 4 to 20 mA analog input signal loss
bYC DC bus charging bypass contactor
EC Earth current failure (ground fault)
HIL High line voltage
HU High DC bus voltage
LU Low DC bus voltage
nCL Network communications loss
OC Overcurrent steady state
OCA Overcurrent while accelerating
OCb Overcurrent during DC braking
OH Drive overtemperature
OL Electronic motor overload
UbS Asymmetrical bus charge
P.044 Fault Auto Reset Time
This parameter
specifies the amount
of time the drive will
wait to attempt to
reset drive faults.
Parameter Range: 1 to 60 seconds
Default Setting: 8
Parameter Type: Configurable
Refer also to parameters: P.043 Fault Auto Reset Attempts