Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual - Manual (Page 9)

III GV3000/SE AC Drive Software Reference, Version 6.06
List of Figures
Figure 3.1 – Keypad/Display .....................................................................................3-1
Figure 3.2 – Example of a Monitor Mode Display .....................................................3-2
Figure 3.3 – Example of a Program Mode Display ...................................................3-4
Figure 4.1 – Parameter Menu Structure....................................................................4-2
Figure 4.2 – Analog Output Selection and Scaling .................................................4-21
Figure 4.3 – Trim Reference Source Selection .......................................................4-23
Figure 4.4 – Draw and Trim Gain............................................................................4-24
Figure 4.5 – S-Curves .............................................................................................4-26
Figure 4.6 – Typical Preset Operation ....................................................................4-35
Figure 4.7 – Drive Start, Stop, and Running Status when Configured
for Edge Control vs. Level Control ......................................................4-45
Figure 4.8 – Sample Alarm Circuit for 1-150 HP Drives Using the Level Sense
Enable Feature ...................................................................................4-46
Figure 4.9 – Signal Selection for Network Output Registers...................................4-52
Figure 4.10 – Volts/Hz Ratio ...................................................................................4-55
Figure 4.11 – Torque Boost Voltage .......................................................................4-57
Figure 4.12 – Avoidance Frequency Band..............................................................4-61
Figure 4.13 – Volts/Hertz Curve Selection ..............................................................4-65
Figure 4.14 – Motor Equivalent Circuit Diagram for Calculating Rotor
Time Constant...................................................................................4-80
Figure 4.15 – Outer Control Loop Proportional Trim...............................................4-90