Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual - Manual (Page 202)

D-2 GV3000/SE AC Drive Software Reference, Version 6.06
Copies of this standard can be purchased from the American National Standards
Institute at www.ansi.org.
EN60204-1
Section Title
9.2.6 - Combined start and stop controls
9.3 - Protective interlocks
9.3.5 - Reverse current braking
9.4 - Control functions in case of failure
9.4.2.1 - Use of proven circuit techniques and components
9.4.3 - Provisions for redundancy
9.4.3.1 - Earth faults
9.4.3.2 - Voltage interruption
10 Operator interface and machine mounted control devices
10.2.1 - Pushbutton colors
10.8 - Displays
11 Control interfaces
11.2 - Digital input/output interfaces
11.2.1 - Inputs
11.2.2 - Outputs
11.3 - Drive interfaces with analog inputs
11.3.1 - Separation between control and electric drives
11.5 - Communications
12 Electronic equipment
12.2.2 - Electronic control equipment
12.2.3 - Equipotential bonding
12.3 - Programmable equipment
12.3.1 - Programmable controllers
12.3.2 - Memory retention and protection
12.3.3 - Programming equipment
12.3.4 - Software verification
12.3.5 - Use in safety-related functions
13 Controlgear: Location, mounting and enclosures
13.2.3 - Heating effects
13.4 - Enclosures, doors and openings
15 Wiring practices
15.1.1 - General requirements
15.1.3 - Conductors of different circuits
15.2.2 - Identification of the protective conductor
18 Warning signs and item identification
18.2 - Warning signs
18.4 - Marking of control equipment
19 Technical documentation
19.1 - General