Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual - Manual (Page 46)

2-8 GV3000/SE AC Drive Software Reference, Version 6.06
Step 5. Program First Menu General Parameters P.000 - P.005
This step describes how to change First Menu General (P) parameters P.000 through
P.005. P.000 selects where the drive is controlled from. This procedure assumes local
control from the keypad (P.000 = LOCL), which is the default setting for the parameter.
Step 5.1 Press the PROGRAM key.
You are now in program mode. The
PROGRAM LED is on and the First
Menu General (P) parameters can be
accessed.
Step 5.2 Press the ENTER key to display the first parameter, P.000, Control Source.
The default setting for P.000 is LOCL, or
local control.
Step 5.3 Press the ▲ key to display P.001, Accel Time 1 (RAMP 1).
This parameter sets the acceleration
time in seconds.
3
)RUZDUG
5HYHUVH
$872
0$1
(17(5
581
-2*
PROGRAM
67$57
6723
5(6(7
63(('
92/76
$036
+]
.Z
72548(
3DVVZRUG
5811,1*
5(027(
-2*
$872
)25:$5'
5(9(56(
352*5$0
5(/,$1&(
(/(&75,&
S
)RUZDUG
5HYHUVH
$872
0$1
(17(5
581
-2*
PROGRAM
67$57
6723
5(6(7
63(('
92/76
$036
+]
.Z
72548(
3DVVZRUG
5811,1*
5(027(
-2*
$872
)25:$5'
5(9(56(
352*5$0
5(/,$1&(
(/(&75,&
SL
)RUZDUG
5HYHUVH
$872
0$1
(17(5
581
-2*
PROGRAM
67$57
6723
5(6(7
63(('
92/76
$036
+]
.Z
72548(
3DVVZRUG
5811,1*
5(027(
-2*
$872
)25:$5'
5(9(56(
352*5$0
5(/,$1&(
(/(&75,&