P.064 option port: network trim reference source, P.065 option port: type and version – Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual User Manual
Page 136
4-50
GV3000/SE AC Drive Software Reference, Version 6.06
The option port trim reference is used as the outer control loop reference and/or the
speed trim reference (see the P.014 (Trim Reference Source) parameter description).
In V/Hz regulation, the trim reference represents speed in hertz scaled 0 to 4095 for 0
to Maximum Speed (P.004).
In vector regulation, the trim reference represents speed scaled 0 to 4095 for 0 to Top
Speed (U.017). When used for the outer control loop, the value should be scaled
based on the scaling of the selected feedback.
Refer to the following option board manuals:
•
AutoMax Network Communication Option Board (D2-3308)
•
ControlNet Network Communication Option Board (D2-3390)
•
DeviceNet Network Communication Option Board (MAN0096-03)
•
PROFIBUS
Interface Board (49’1355)
•
Super Remote Meter Interface Board (D2-3341)
OCL Reference Selection (FVC/SVC Only)
The parameter is also used to select the OCL reference. Refer to Appendix H for more
information.
The display format is N.vvv, where N represents the option type (1 = RMI,
2 = AutoMax network or
PROFIBUS
network, 4 = DeviceNet network, and 5 =
ControlNet network) and vvv represents the software version number.
For example, if 2.103 is displayed, it means the drive is using the AutoMax network
option running software version 1.03.
P.064 Option Port: Network Trim Reference Source
This parameter
specifies where the
drive gets its trim
reference when the
option port is
selected as the
control source
(P.000 = OP)
.
Parameter Range:
Option board-dependent. See option board
instruction manual.
Default Setting:
0
Parameter Type:
Configurable
Refer also to parameters:
P.063 Option Port: Network Reference Source
U.000 Torque Reference Source
P.065 Option Port: Type and Version
This parameter
displays the option
type and the software
version number of the
option board.
Parameter Range:
N/A
Default Setting:
N/A
Parameter Type:
Read only
Refer also to parameters:
N/A